More videos from: Craft How-To's
- Rate this Video:
Hi I'm Lee Woodruff.
And I'm Tierra.
And were at the craft table with family fun. Add some glamour to your little girl's party with the sparkling water bracelets.
For 3 bracelets you'll need 2 feet of clear vinyl tubing with an outer diameter of 3/8 of an inch and then three inches of tubing with the 3/8 of an inch inner diameter, a ruler, scissors, water, a funnel, and tiny beads or glitter. Start by cutting an 8î inch piece from the thinner tubing and 1î inch from the fatter tubing since its larger the 1î inch piece will act as your fastener. Next size the bracelet slide both ends of the eight inch tubes into the fasteners and be sure to slide it on your child's hand if it's too big trim it to fit remove one end from the fastener and use your finger to plug the end, like so, while your child drops in the glitter or beads using the funnel. Then slowly fill the tube with a tiny bit of water and leave some air so the glitter and beads have room to move around now carefully slide the free end into the fastener as far it will go but make sure the fit is snug. Absolutely fabulous making these bracelets is so much fun you can bet the girls won't make just one."
- From our provider: FamilyFun
- Add some glamour to any party with these sparkling bracelets.