Since many readers asked for valentines to give a teacher, we came up with this easy doily flower. But of course, teachers aren't the only ones who'd appreciate one, or an entire bouquet, of these lacy blooms.
| Prep Time: Under 1 hour | |
| What you need: | |
|
Materials for 1
2 round paper doilies or 2 heart-shaped doilies (we used 6-inch doilies, available at craft and party stores and www.orientaltrading.com) Pencil 12-inch green pipe cleaner Tacky glue (optional) Scissors Green card stock Hole punch Pen Paper clip | |
| Seasons: Valentine's day | |
| Materials: doilies | |
| Instructions: | |
| 1. | Lay a doily flat on the palm of your hand. Press the eraser
end of a pencil into its center and gather up the doily into a
ruffle. Repeat with the second doily.
|
| 2. | Place 1 ruffled doily on top of (but not inside of) the
other to form the flower and wrap the doilies tightly with one
end of the pipe cleaner as shown. If you want a stronger bond,
wrap tightly 1 or 2 times, then add glue to the doilies and
continue to wrap over the glue. Allow the glue to dry. |
| 3. | Cut a heart-shaped leaf from green card stock. Use a hole
punch to make a hole near the bottom. Write your message on the
leaf. Slide the pipe cleaner stem through the hole and add a dot
of glue where the leaf rests against the stem. Use a paper clip
to hold the leaf in place until the glue dries.
More Valentine Gifts » |
© FamilyFun. All rights reserved.

Lay a doily flat on the palm of your hand. Press the eraser
end of a pencil into its center and gather up the doily into a
ruffle. Repeat with the second doily.
Place 1 ruffled doily on top of (but not inside of) the
other to form the flower and wrap the doilies tightly with one
end of the pipe cleaner as shown. If you want a stronger bond,
wrap tightly 1 or 2 times, then add glue to the doilies and
continue to wrap over the glue. Allow the glue to dry.
Cut a heart-shaped leaf from green card stock. Use a hole
punch to make a hole near the bottom. Write your message on the
leaf. Slide the pipe cleaner stem through the hole and add a dot
of glue where the leaf rests against the stem. Use a paper clip
to hold the leaf in place until the glue dries.


