Ask any motorcyclist: when it comes to bikes, the louder the better! Each plastic plate yields two of these noisy "clackers," an easy way to rev up your bike. It also makes a fun craft for your guests at the Ultimate Bike Birthday Party.
| Prep Time: Under 1 hour | |
| What you need: | |
| 9-inch plastic plates
Hole punch Plastic cable ties Scissors | |
| Seasons: Birthday | |
| Materials: plastic plates | |
| Instructions: | |
| 1. | 
BEFORE THE PARTY Cut the rim off one 9-inch plastic
plate for every 2 guests. Mark 2 rectangles side by side inside
the flat circle, as shown. Cut out the rectangles and, using a
hole punch, make a hole halfway down each long side. |
| 2. | AT THE PARTY Insert a plastic cable tie into each hole in the rectangle, then secure it around one of the bars that extend alongside the bike's back wheel. Be sure the "engine" makes contact only with the spokes, not with the chain or brakes. Tighten the ties and trim off the ends. |
© FamilyFun. All rights reserved.
