Shimmering Fairy Wings

By Cindy Littlefield

Rated by 4 members

1 Comment

You can't be a fairy without a proper set of wings. And, just like snowflakes, no two sets are exactly alike. Each is as unique as the fairy who wears them. If you happen to know an aspiring fairy who is ready for her first wings, you can easily conjure up a set from a pair of sheer white tights and a few other basic materials. Once the wings are constructed, the young recipient can add her own personal touch by adorning them with glitter glue pixie dust, craft feathers, and other decorative notions.

You'll need:

Wire cutters
Tape measure
16-gauge general purpose wire (sold in most hardware stores)
Duct tape
Sheer white tights
Hot glue gun
Wide white sewing elastic
Two 4-inch squares of white felt
Faux white fur, white craft feathers, and/or white curly ribbon
Glitter glue
Small paintbrush

Instructions:

1. Cut two 29-inch lengths of wire to use for the top set of wings and two 26-inch lengths for the bottom set.

2. Form a circle with each wire length, overlapping the ends by an inch and taping them firmly together. Make sure the edges of the tape are well pressed down so there are no rough edges for the wing material to catch on.

3. Stretch one of the legs of the tights over one of the larger circles so that the top of the wing fits snuggly into the toe. (The wire circle will naturally narrow in the process due to the tension exerted by the stretchy material.) Gather the tight at the bottom of the wing, pulling it taut. Then cut the material 2 or 3 inches from where you are holding it and tightly knot it. Use the other leg of the tight to cover the second larger circle in the same manner.

4. Cut the remaining leg portions from the tights (they should resemble short tubes) and use them to cover the smaller wire circles as you did the larger ones. Note: Because there's no toe in these sections, first you'll need to turn each tube inside out, tightly knot the top, and then turn the tube right side out again.

5. Next, cut a pair of 18-inch lengths from the sewing elastic to use for shoulder straps. Glue the ends of each strap to the sides of one of the felt squares, as shown.
6. Glue the bases of a top and bottom wing securely to one side of the felt square (make sure you don't mistakenly glue down the elastic strap in the process). Glue the remaining two wings to the opposite side.
7. For the finishing touch, glue the second felt square on top of the wing bases and decorate it with faux fur, craft feathers, and/or ribbon.

See More Disney Fairy Crafts & Recipes >

Member Comments On...

Shimmering Fairy Wings

Grandmother_of_2 says:

April 15, 2009

Note to crafters: 9 feet. That's how much wire you'll need *if* you subtract an inch from the smaller wings (from 26 to 25 inches).

That's easier to order-up at the hardware store than the original dimensions (which add up to 9-1/6th [9.2] feet ;)

And you'll need 36 inches (3 feet) of "wide white" sewing elastic. ;)

*** Note to DisneyFamily.com ***
It's very handy to have amounts/quantities in the materials ("You'll need") list. That makes it much easier to shop! :)